I notice this on my new taig mill. But, am not sure if that is the way
it is supposed to work.
I have not yet attached the motors to the mill. On each axis, there is
the locking nut at the end, next is the cylinder with 4 holes to the
side, and, next to that is the dial.
I notice that on the x and y axis, when I move the dial the axis moves
forward or backward. But, on the z-axis, I notice that when I rotate
the dial, it does not move the axis. The dial rotates but not the
axis.
Is that how it is supposed to work? All I did until now after the taig
arrived is to assemble the z axis following the video on deepgrove1
website.